There are many things that
Aluminum Profile manufacturers need to pay attention to when producing
Aluminum Profiles. They must be standardized when handling, so that they will be more beautiful and durable in future use. Write them down and let's take a look at the details that need to be paid attention to.
1. Issues to pay attention to in the spray booth: Before officially spraying powder, you can try spraying several times. At this time, you can observe the amount of powder and the uniformity of powder distribution at both ends of the spray booth. At this time, the powder runs in a straight line within 10cm from the end of the spray claw. The powder adsorbed on the surface of the profile is actually the powder with this atomization effect. Whether the powder with this atomization effect is used to control the distance between the spray claw and Standard for the distance between profiles.
2. The production of clamps and the selection of loading methods: The clamps hung at both ends should ensure that they can withstand considerable pressure; the clamps used in the middle should be made and used to minimize the impact on the outer surface of the clamps and profiles. The size of the contact point, and the vertically placed hanging rod parts must be replenished in time. The position of the profile in the hanging device must also follow the corresponding principles.
3. The more common pre-treatment procedures before oxidation are simple, mainly degreasing and chromating, and the raw material consumption is low. In order to improve production efficiency and reduce energy consumption during the drying process during pre-treatment, larger racks are often used to hold as many profiles to be processed as possible.
4. When the drying process is completed and there is still moisture remaining, in order to avoid damaging the oxidation film on the surface of the profile and the profile being easily deformed when the temperature is too high, it should not be put into the oven for baking. You can use a cool oven. Dry or blow dry with an air gun.
In short, when producing aluminum profiles, manufacturers should pay attention to the above-mentioned details, which can extend the service life in the future.
